Two-Step Stool
A sturdy two-step stool with a wide top and splayed legs for stability. Built to hold an adult standing on the top step.
Difficulty Beginner Category Furniture Time 110 min Cost $28 Primary wood Pine
01Materials
- 1×10 pine, 4 ft (top)
- 1×8 pine, 6 ft (steps and risers)
- 1×4 pine, 6 ft (legs)
- 1-1/4 in screws
- Wood glue
02Cut List
| # | Part | Dimension | Note |
|---|---|---|---|
| 01 | 2 × 1×10 | 16 in | top and second step |
| 02 | 2 × 1×8 | 14 in | risers |
| 03 | 4 × 1×4 | 10 in | legs, cut 8 degrees on ends |
| 04 | 2 × 1×4 | 14 in | cross braces |
03Tools
- Miter saw
- Drill/driver
- Speed square
- Clamps
- Sander
04Build Steps
- Cut the parts. Cut the steps, risers, legs and braces. Cut the legs at 8 degrees top and bottom so they splay slightly.
- Build the sides. Screw the legs to the risers to form two matching side frames, keeping them square.
- Join the sides. Attach the steps across the two frames, then add the cross braces front and back.
- Reinforce. Add a block under each step joint and check that all four legs sit flat on the floor.
- Finish. Sand edges and apply a non-slip paint or clear finish.
Safety First
- Test the stool with your full weight on the top step before daily use.
- Keep all four feet flat — a rocking stool is a fall hazard.
05Pro Tips
- Add a non-slip strip to the top edge for safety.
- Splay the legs about 8 degrees for stability without extra bracing.
